Primer application
The primer went on like a dream. I only put one coat and that covered good. The paint went over the primer very well.
METCOTE™ is a quick-drying single-pack anti corrosion heat-resistant etch primer polyvinyl butyral coating for non porous surfaces. It can be used on iron, steel, aluminum, fiberglass, galvanized metal, concrete, and other porous surfaces.
METCOTE™ is a quick-drying single-pack anti corrosion heat-resistant etch primer polyvinyl butyral coating for non porous surfaces. It can be used on iron, steel, aluminum, fiberglass, concrete, and other porous surfaces.
PRODUCT USES
ADVANTAGES
COLOR
Ivory
COVERAGE
Approximately 145 sq. ft./quart.
SURFACE PREPARATION
All surfaces must be clean of dirt and release agents, dry, firm and free of rust and mill scale. All surfaces should be roughened. METCOTE will provide a fair bond to smooth surfaces, but roughening the surface will greatly improve adhesion.
Iron
Abrade the surface with 60 to 80 grit sand paper. If abrasive blasting is desired, the blast profile should not exceed 50 microns (or 2 mils).
Aluminum
Abrade with 60 to 80 grit sandpaper, then rinse with solvent (listed above).
NOTE: The finished surface on all substrates should have a scored, roughened profile for best adhesion.
APPLICATION
APPLICATION TEMPERATURE
23°F - 122°F
NOTE: Lacquer thinners must not come into contact with DURABAK™ or DURABAK 18™ Allow METCOTE™ to dry completely before overcoating with either DURABAK™ or DURABAK 18™ 4 hours after METCOTE is applied.
Weight 3 lbs
Dimensions 3 × 3 × 14 in
The primer went on like a dream. I only put one coat and that covered good. The paint went over the primer very well.
Quick ship. Expensive but worth it.
I love it... definitely i will use it again
Great product